Wednesday, 19 September 2012

Heating laser cutting

This is my second attempt at heating using the heat gun. It is easy to see that it is a lot better then my first attempt. I drew on the edges of the twirl with a blue vivd which gives an effective aesthetic. I still have 2 spirals so I am going to heat those and make them even better than this one. 

This is the first trial of heating my spiral. As you can see it didn't quite go to plan as the heat distribution was not even. I did this using a blowtorch however I am going to use the heat guns in order to get a more even distribution.

No comments:

Post a Comment